[Chia sẻ] Vivi Y11 Mã Bảo Vệ by UMT

Thảo luận trong 'Kỷ thuật phần mềm'

  1. Tùng Nguyễn GSM

    Tùng Nguyễn GSM Tùng Xe Ôm Vip Moderator

    Tham gia ngày:
    3/9/17
    Bài viết:
    298
    Đã được thích:
    233
    Giới tính:
    Nam
    Nghề nghiệp:
    Giữ trẻ 18 tuổi
    Nơi ở:
    Sao Hỏa
    Trả máy khách rồi nên k có ảnh,anh em gặp múc
    Chia sẽ cho có data
    Device : Vivo V11 Pro
    Operation : Vivo Format FS / FRP Reset
    Checking for existing devices...Not Found
    Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
    Some phones may need Special Boot Cable or TestPoint for EDL mode.
    Found Port : Qualcomm HS-USB QDLoader 9008 (COM21)
    Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.7
    Connecting to phone...OK
    Waiting for response...OK
    Init Handshake Sequence...OK
    Hardware ID : E1F00B00 [8937] 00000000
    OPK_DATA : 30315EBED1DD09CEAAE927CAE0EE967076BC178CA33718DB4FFF8F02A0E7FAD2
    Initializing Protocol...OK
    Using Auto Loader Selection [1]
    Preparing Loader...Done
    Sending Loader [8937_029]...Done
    Executing Loader...OK
    Detecting Chip Type...OK
    Hardware : 8937, eMMC, 32 GB
    LU Count : 1 [0x03A3E000]
    WARNING! High Speed Driver is not installed.
    Please install driver from QcFire\Drivers folder using Device Manager.
    Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
    Reading Partition Table...OK
    Reading Device Information...OK
    Device : vivo vivo 1906 [PD1930F_EX]
    Software : PKQ1.190616.001 release-keys, compiler12261558 [Sat Dec 28 00:52:38 CST 2019]
    Android Ver. : 9
    Patch Level : 2019-12-01
    Formatting userdata...Done
    Resetting FRP Lock...Done
    Wipe cache / userdata from Recovery and reboot.
    First startup may take 2-5 minutes.
    Operation Finished.
    QcFire Ver. 5.2
     
    dongnaigsm thích bài này.